Please see below the Peoplesafe Body Worn Camera Configuration Guide
Configuration steps;
- When logged into Dems360 select the Administration then Camera Settings
- Once complete select save and then plug in the camera/s for a minimum of one
minute to configure the settings
- Select the settings tab
- Select Default D5 (D5) from the dropdown
- Check the settings against the images shown and make sure the settings match as
shown below
- Once complete select save and then plug in the camera/s for a minimum of one
minute to configure the settings
- Select the settings tab
- Select Default D5 (D5) from the dropdown
- Check the settings against the images shown and make sure the settings match as
shown.
- Open your Peoplesafe Application – making sure that your bluetooth is switched on
and available to the application in your settings
- Press and hold the SOS button for 4 seconds to raise an alarm
- The Body Worn Camera should start start to record – an audible beep will be heard,
the screen will brighten and a red led will show if the settings have been applied
correctly
- Once you are finished recording, slide the red recording slider down and then back up
to stop the recording.
